TOOLING NEWS |
|
 |
|
 |
 |
TRUMPF Tool Data Import |
|
|
|
When ordering a custom punching tool, TRUMPF customers will, in future, automatically receive on disk, all the data required for programming at the machine itself. This will eliminate the need to draw the tool and therefore takes no more than a few seconds to enter new tools in ToPs300. Besides shortening the programming time, Tool Data Import also helps to avoid incorrect angles and valuable start-up times at the machine. |
| |
 |
|
Lifelong Warranty against die breakage |
|
|
|
Calculations according to the Finite-Element method prove it - with the newly computed die geometry, the new TRUMPF dies feature highest possible load capacity. This is supported by an optimised number of grooves. TRUMPF therefore offers life-long warranty against breakage for standard dies. This is valid until the maximum regrind amount of 1mm is reached, provided the die is utilised according to its intended use. No liability accepted for consequential damages. |
| |
 |
|
10-station Multitool |
|
|
|
Following the successful introduction of the 10-station Multitool die adapter with exchangeable inserts, TRUMPF will now offer this as a standard tool. When ordering a 10-station Multitool as a complete tool, the customer will always receive an adapter for exchangeable inserts. For further details on any of the above products, e-mail sales@uk.trumpf.com |
| |
|
|
){kind=small}
){kind=small}
){kind=small}